Before Takeoff

Seat Belts Sign	On	If "Enable seatbelt signs check" option set to true
Landing Lights	On
Runway Turnoff Lights	On
Taxi Lights	On or Off	On if "Taxi lights ON during takeoff" option set to true, otherwise off
Strobe Lights	On
Wing Lights	On	If "Enable wing lights ON" option set to true or is dark
Logo Lights	On	If dark
Transponder	TA/RA or TA	TA if "Set TCAS to TA Only" option set to true, otherwise TA/RA
Packs	Off	If "Set packs off" option set to true
Auto Landing Lights	Arm

After Landing

Speed Brakes/Spoilers	Retract	If "Enable speedbrake retraction" option set to true
Flaps	Up	If "Enable flaps retraction" option set to true
Transponder	XPNDR
Landing Lights	Off
Runway Turnoff Lights	Off	If "Turn runway turnoff lights off" option set to true
Taxi Lights	On
Wing Lights	Off	If "Turn wing lights off" option set to true
Strobe Lights	Off
APU	On

Auto Landing Lights

• Automatically turn the landing lights and other lights off/on when passing through a certain altitude.
• You must ARM it by clicking on the widget, and it will turn orange. Then, while the airplane crosses the specified altitude, the actions will be triggered accordingly.
• Executing the Before Takeoff widget will arm this automatically. Don't forget to arm it again before descending.
• The altitude reported by MSFS might be different from the one shown on the PFD, so giving some margin is recommended.

	Off (ascending)	On (descending)	Specified by "Lights off/on altitude"
Landing Lights	Off	On
Runway Turnoff Lights	Off	On
Taxi Lights	Off	On
Wing Lights	Off	On	If "Enable wing lights ON" option set to true or is dark
Logo Lights	Off	On	If dark
Seat Belts Sign	No Change	On

Heading Sync

• The widget shows the current actual heading when idle, and the MCP heading when scrolling.
• Click on the widget to sync the MCP heading to the current heading.
• Scroll on the widget to change the MCP heading.
• Use OTTO to set the heading to a value. An example command would be "hdg 200".

Set IAS

• The widget shows the current IAS/Mach speed (or a blank value) shown on the MCP.
• Scroll on the widget to change the MCP speed.
• Use OTTO to set (and intervene) the speed to a value. Some example commands would be "spd 180", "ias 180 intv", "mach 0.82", "spd intv", etc.